Pipe clamp is a kind of workpiece used to grip and rotate steel pipes. It can be divided into many kinds according to the carrying capacity, weight, style, etc., and is widely used in the installation of oil pipelines and civil pipelines. So how do aluminum alloy pipe pliers operate? The following Xiaobian take you to understand.
1. Before using the aluminum alloy pipe clamp, check whether the surface of the tool is damaged, the pipe clamp teeth are free of foreign bodies and are fixed well, whether the size of the pipe clamp is consistent with the size of the pipe clamp, and whether the pipe is fixed.
2, then adjust the opening of the pipe clamp, hold the pipe clamp handle with the right hand, turn the adjusting coil with the left hand, so that the opening distance of the clamp mouth is greater than the diameter of the clamped pipe fitting 1 ~ 2mm. Then clamp the pipe clamp on the pipe body, and put the clamp on the pipe body 10 ~ 20cm away from the end of the connection thread. The clamping direction of the clamp mouth is consistent with the rotation direction of the handle.
3, standing adjustment, the legs are shoulder width apart, the left hand slightly press the head of the clamp, to ensure that the clamp teeth do not slip, hold the handle with the right hand to press down hard, when the pressure is fast to a lower position, the right hand five fingers release by the palm of the palm to press to a lower position, and then the right hand to lift the handle at the same time, the left hand hold the mouth of the plate to prevent the clamp from slipping.
4, after the use, do not forget to clean up the site, remove the aluminum alloy pipe clamp, restore the original state after wiping the tools, placed neatly.
When the pipe clamp is used, pay attention to the bearing torque and do not use overload. Not to be used as a hammer to strike steel workpieces.